Operation Manual

INSTALLATION

DIN FRONT-MOUNT (Method A)

Installation Opening

This unit can be installed in any dashboard

having an opening as show below:

Installing the unit

Be sure you test all connections first, and then follow these steps to install the unit.

1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle

battery’s negative (-) terminal.

2. Disconnect the wire harness and the antenna.

3. Press the release button on the front panel and remove the control panel (see the

steps of “using the detachable front panel”).

4. Lift the top of the outer trim ring then pull it out to remove it.

5. The two supplied keys release tabs inside the unit’s sleeve so you can remove it.

Insert the keys as far as they will go (with the notches facing up) into the appropriate

slots at the middle left and right sides of the unit. Then slide the sleeve off the back

of the unit.

6. Mount the sleeve by inserting the sleeve into the opening of the dashboard and

bend open the tabs located around the sleeve with a screwdriver. Not all tabs will

be able to make contact, so examine which ones will be most effective. Bending

open the appropriate tabs behind the dashboard to secure the sleeve in place.

Sleeve

L Key

Outer Trim Ring

Front Panel

R Key

Tabs

Dashboard

Sleeve

Screwdriver