Operation Manual

GB - 9

RADIO OPERATION

1. Press RADIO ON button once to turn on radio power,

RADIO will light up on the LCD.

3. Press the TUNE/TIME button + or – momentarily (less than 0.5 sec.) to step up or down

the receiving frequency in order to select the desired station.

3. For auto tuning, keep pressing the TUNE/TIME button + or – (more than 0.5 sec.) until

the displayed frequency starts to change, then release the button. Tuning will stop

automatically when a station is received.

4. Adjust the sound level by pressing VOLUME +/– buttons.

5. To turn the unit oﬀ after use, simply press STOP/OFF button once.

NOTE: After radio frequency is displayed for about 10 seconds, the LCD will show the current

time. Pressing the RADIO ON button once will show radio frequency again.

Improving the reception

• Extend the FM wire antenna which is located on the back of unit, and change its position

until the best FM reception is found.

• Install the unit as far as possible from a source of noise. (for example : refrigerator,

microwave oven, ﬂuorescent lamp, etc.)

PRESET STATIONS

1. Press the RADIO ON button.

2. When the desired station is tuned, press CD MODE /

PROGRAM button to enter saving mode.

3. The preset location will ﬂash on the LCD, press PRESET

/ button to select preset channel.

4. Press CD MODE / PROGRAM button again to save into memory. If it has previously

set, the former station is replaced.

5. Repeat step 1 ~ 4 to store more preset stations.

NOTE: The preset memory can store a maximum of 12 stations for FM band

RECALL A PRESET STATION

To recall any preset stations within the selection, simply press the PRESET

buttons until the preset radio frequency appears on the display.