User guide

24 User Guide
PASSWORD
You can change the default SYSTEM password via this option.
1. SELECT the PASSWORD option on the System Menu.
2. SELECT the SYSTEM password option.
3. You are then prompted with NEW SYSTEM PASSWORD.
4. Type in the new password (use CLEAR to backspace if you make a
mistake) and then press OK.
5. A confirmation screen is then displayed, asking you to re-enter the new
password. Type it in again, and then press STORE to store the new
password.
6. You are then returned to the Password Menu. Press BACK to go back to
the System menu.
LOCK CODE
You can change the 4-digit handset lock code with this option.
1. SELECT the LOCK CODE option on the System Menu.
2. You are then prompted to enter the new Lock Code. Type in the new
Lock Code (use CLEAR to backspace if you make a mistake) and then
press OK.
3. A confirmation screen is then displayed, asking you to re-enter the new
code. Type it in again, and then press STORE.
4. You are then returned to the System Menu.
BEAM SIGNAL OFF/ON
This option gives you the ability to enable or disable the display of the beam to
which the radio has logged-on as well as the received signal strength. When
the option shows BEAM SIGNAL: OFF and you SELECT it, the option
changes to BEAM SIGNAL: ON and the beam display is enabled. When the
option shows BEAM SIGNAL: ON and you SELECT it, the option changes
to BEAM SIGNAL: OFF and the beam display is disabled.
When enabled, the beam display appears in:
 Idle State
 Call