User guide

22 User Guide
1. SELECT X-OVER and the following beam regions are displayed:
• B0 – EAST
• B1 – EAST C
• B2 – WEST C
• B3 – WEST
• B4 – SOUTH
• B5 – A/H
2. Navigate the list with the up/down arrows and SELECT the desired
beam.
3. You are then asked to confirm the selection by a Continue? prompt.
Press YES to continue, or press NO to cancel and return to the beam
region options.
Throughout the cross-over process, the beam to which the radio is crossing-
over flashes (e.g., X-OVER: B1- EAST). The
icon is displayed until the cross-
over process is complete. The BEAM/SIGNAL monitor is displayed
throughout this process regardless of whether or not it is active. The current
beam is displayed, and then the selected beam region is shown as the process
is completed (i.e. B1 S55 to B0 S55). Once the process is complete, the beam
to which the radio has crossed-over is displayed for three seconds. You are
then returned to the Idle display.
If you have selected a beam that is not accessible, “X-OVER FAILURE” will be
displayed for several seconds. You will then be returned to the beam options
list. Ensure that you have chosen the proper adjacent beam before initiating a
manual beam cross-over.
Note that the radio automatically performs a beam cross-over sequence when
required (e.g., traveling between beams).
BACKLIGHT
This option allows you to control the display’s backlight. Press SELECT to go
through the three different options for backlight display:
1. EVENT – The default configuration. The backlight is displayed for a short
time after any key other than PWR or PTT is pressed, and the timer is
restarted when any other key is pressed.
2. CONSTANT – The backlight is always ON.
3. OFF – The backlight is always OFF.