MXS-532131 MST FXX-D S IFS Manual

ON ROAD USE ONLY

FULL BALL BEARINGS

WHEELBASE :

WIDTH :

GEAR RATIO :

CASTER :

STANDARD 257mm (adjustable)

STANDARD 190mm (adjustable)

2.12 (36T/17T)

8 degrees variableness

www.rc-mst.com

INSTRUCTION

MANUAL

DRIFT CHASSIS

IFSIFS

※SPECIFICATION ARE SUBJECT TO CHANGE WITHOUT NOTICE

PAGE 1
IFS 10 DRIFT CHASSIS INSTRUCTION MANUAL ON ROAD USE ONLY FULL BALL BEARINGS WHEELBASE : WIDTH : GEAR RATIO : CASTER : STANDARD 257mm (adjustable) STANDARD 190mm (adjustable) 2.12 (36T/17T) 8 degrees variableness www.rc-mst.
PAGE 2
FXX-D S IFS 1 / 10 DRIFT CHASSIS 2 PARTS BAG FXX-D S IFS FXX-D S IFS Please read this additional instructions before assembly. Please change below FXX-D S assembly steps for FXX-D S IFS conversion. 1. BAG 2 STEP 1 2. BAG11 3. BAG14 STEP 1 ~ STEP 4 4. BAG15 STEP 2 Please refer both FXX-D S and this additional instructions. ! FXX-D S 1. BAG 2 2. BAG11 3. BAG14 4.
PAGE 3
UPPER DECK Attaching upper deck STEP 1 BAG 19 9 M3 12 screw BAG 14 4.8 Copper hex ball 4 8 110029 8 M3 Damper holder BAG 4 3 6 14 M3 8 12 2 230004 7 Damper holder 4 M2 4 M3 3.50 11 PARTS BAG 6 4 M2 5 5 1 upper deck B 3 battery presser 8 BAG 14 M3 8 6 3 2 gyro mount 6 7 Damper holder 8 M3 9 6 M2 6 M2 6 M2 5 BAG 12 14 4.
PAGE 4
14 PARTS BAG BAG 19 DAMPER STAY STEP 1 230004 L arm assembly STEP 3 L 2 4.8 Attaching L arm holder L 4.5 copper ball connector 1 L Arm L arm holder 3 5 1 L L arm L 4.8 2 4.5 copper ball connector 310054 M3 12 screw 2 M3 20 screw 2 110029 110009 4.8 18 adjuster 210095 8 2.5 bearing 4 ball bearing seat 4 2 4.8 STEP 2 Turnbuckle assembly X2 4 4.5 copper ball connector 4.8 Make 2 M3 18 adjuster 11.5 2 BAG 14 3 8 screw 20 screw 1 L arm holder 1:1 5 8 2.