Owner`s manual

C. Assembly

˅˄

˅ ˄

˅˄

E-1

E-2

(F-1) (F-2) (F-3)

A. Connect each piece of foam mat to make a square mat. Place the heat preservation foam mat underneath

the spa tub.

Temp barrier mat can prevent heat loss from bottom of the unit and provide better heat preservation

with together of the inflatable bladder being used. It is possible to install and leave the spa tub outside at a

temperature below 4°C(40°F), but only if the water temperature inside the pool is higher than 4°C(40°F) and

water in pipe is not frozen. The spa tub can be operated in cold weather with temperature down to maximum

-10°C(14°F) if the unit is properly set up and no frozen water inside the control box, pipes or spa pool. It’s

helpful to put temp barrier mat in between the spa pool and the ground. Similar mat which is made of foam

material or other materials with temp barrier function can also be used.

B. Before proceeding any further, please find Joint Panel and be sure that this is where you wish to locate

your control box. The first side of the spa is where the control box will be connected and located. Also note,

the Corner Beams shall face outward with the side including bluckle plate, and snap end is up, otherwise the

assembly will be failed finally.

C. Slide Corner Beams onto each side of the Joint Panel. Then continue attaching Skirts and Corner Beams

until eight sides of the spa are in place.Slide Skirt into the eighth side of the spa so that it rests on the Corner

Beams. Please double check and ensure that eight sides of the spa are in place.

D. Place Comfort Rails around the top of the spa skirts. Please note the shorter side of Comfort Rail shall face

to the spa pool.

E. Place the Liner inside the spa.

Note: The pipes protruding from the Liner shall face to the Joint Panel and go through the holes of it. Stretch

the coloured portion of the Liner over the Comfort Rails and snap onto the metal snaps on the Corner Beams.

Once all eight snaps have been fixed, you may have to readjust the Comfort Rails so they sit squarely on top

of the Skirt. Do this by undoing each snap, repositioning the Foam, and redoing each snap, one at a time.

Note: Push the bottom edges of the Liner tight to the Skirt to remove any wrinkles in the Liner.

F. Connect the control box fittings to the pipes protruding from the Liner. Be sure that the rubber gaskets are

in place on the control box fittings. Hand tighten only, holding each pipe steady and twisting only the fittings.

Fit the foam connection pieces between the spa and control box until it hold firm. Wrap the foam connection

piece with the PU leather strip.

Don’t install Mspa onto the lawn as grass may cause air pump damped and rusted

which could result the air pump works improperly and will void your warranty.

Meijer.com