Owner`s manual

Spa Storage

Make sure all water is drained from the Spa and control box. This is essential to extend the life of the spa.

We recommend the use of a wet/dry vacuum to blow out or suck up water from the Spa pipes and Pump

lines. Remove the Filter Cartridge. It is recommended you store the spa in its original package in a warm

dry place.

NOTE: Make sure all components are completely dry and clean before re-packing.

Store safely in dry condition and out of sunlight.

Plastic becomes brittle and susceptible to breakage when exposed to subzero temperatures.

Freezing can severely damage the Spa. Improper winterization of your Spa may void your warranty.

DISPOSAL

1.The marking indicates that this product shall not be disposed with the general household waste.

Please contact your local community about collection points or ask your dealer.

2.This product contains valuable materials that can be recycled and contribute to a sustainable

enviroment.

3.For recovery, recycling and dismantling information for this product, please visit us at

www. the-mspa. com

TROUBLESHOOTING

Mspa® strives to provide the most trouble-free spas on the market. If you experience any product related

problems, do not hesitate to contact us or your local after sales service center.

Here are some helpful tips to help you to diagnose and rectify some common sources of trouble.

*For any spare parts you need for replacement, please refer to the warranty policy for replacing details.

*For any other unknown failures out of the list, please contact your national or regional MSpa service cen-

ter.

Spa checklist before unpack the unit and re-use for the new season:

In order to have your MSpa runs smoothly and easily for another new season, make sure you do the follow:

1. Check if there is water in the air pipe. If any water is found, dry the air pipe before operating the spa tub.

2. Connect control panel correctly, turn on the spa tub, check if LED displays correctly and if the signal cable

is connected properly.

3. Press ON / OFF button on the control panel, open bubble function, check if it operates properly.

4. After doing the above steps, your MSpa should be ready for use. Enjoy it!

Any damage caused by improper storage or failure to do the checklist of reuse will void your warranty.

Meijer.com