Meijer.com Owner′s Manual and Warranty B-160 Tuscany B-170 Tuscany Grande DO NOT RETURN MERCHANDISE DIRECTLY TO YOUR ORIGINAL SELLING STORE. CALL MSPA AFTER SALES SERVICE CENTER FOR ANY PRODUCT QUESTIONS. CONTACT US AT info@the-mspa.
SAFETY INSTRUCTIONS WARNING Meijer.com When installing and using this electrical equipment, basic safety precaution should always be followed. IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS. WARNING: Risk of electric shock. Insert the plug only to a properly grounded socket. WARNING: This product is provided with a ground-fault circuit-interrupter. The GFCI must be tested before each use. With the product operating, open the service door.
Meijer.com WARNING: TO AVOID THE ELECTRIC SHOCK, DO NOT USE THE SPA WHEN IT IS RAINING OR THUNDERING AND LIGHTENING. WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times. WARNING: Water attracts children. Always have the spa locked after each use. WARNING: Pets should be kept away from spa to avoid damage and/or accidental drowning. WARNING: Modifications are not approved by the party responsible for compliance.
Meijer.com H. Obese persons and persons with a history of heart disease, low or high blood pressure, circulatory system problems, or diabetes should consult a physician before using the spa. I. Persons using medication should consult a physician before using a spa since some medication may cause drowsiness, while other medication may affect heart rate, blood pressure, and circulation. WARNING: TO REDUCE THE RISK OF INJURY: Never pour water higher than 40°C (104°F) into the spa pool directly.
Meijer.com SPECIFICATIONS Style No. B-160 Tuscany B-170 Tuscany Grande Pool Shape Octagon Octagon Seating Capacity 4-5 5-6 Water Capacity(Approx.) 860L/227gallons 1200L/317gallons Net Weight(Approx.) 60 kgs/132 lbs. 70 kgs/154 lbs. Outside Dimensions 1.62m/64″ 1.93m/76″ Height 0.68m/27″ 0.
Meijer.com A. Site Requirements WARNING: The floor has to be capable of supporting the expected load. WARNING: An adequate drainage system has to be provided to deal with overflow water. IMPORTANT: Because of the combined weight of the spa, water and users, it is extremely important that the base where the spa is installed is smooth, flat, level and capable of uniformly supporting the weight for the entire time the spa is installed.
Meijer.com C. Assembly ˄A˅ ˄B˅ ˄C˅ ˄E-2˅ (F-1) (F-2) ˄D˅ ˄E-1˅ (F-3) A. Connect each piece of foam mat to make a square mat. Place the heat preservation foam mat underneath the spa tub. Temp barrier mat can prevent heat loss from bottom of the unit and provide better heat preservation with together of the inflatable bladder being used.
G. Screw the control panel onto the spa, fasten the ring to the pipe adaptor. Precautions: 1. When using the spa tub outside, air pipe can not be taken off. Do not use the spa tub in rains as air pump will not working properly. 2. The two O-ring part on the air pipe is important to get the spa tub working properly. Lost of the O-rings could cause air pump rusted or not working properly. Missing of the O-rings also affects bubbling function. H. Connect the pin plugs.
Meijer.com POWER PACK OPERATION Warning: to avoid function failure and damage, please do not operate until spa is filled with water to the low water mark. It is the responsibility of the spa owner to make sure the above installation conditions are met as well as to follow the Safety and Warning Instructions. Any failure and damage, which may result from dry-run, water spillage, excessive humidity, or structural loading will void the warranty. Control panel: 1. “ON/OFF” Button: To activate power pack.
Meijer.com So you are recommended to fill spa with warm water for quick heating and energy saving. Maintaining Spa Water Poor water quality can be extremely hazardous to your health. We recommend you do following things: A: Please use filter cartridge. Screw the filter onto the water inlet（lower fitting） on the spa wall by turning it clockwise. Note: Two filter cartridge, one is for use, one is spare. Note: Do not use filter cartridge when only to heat water and to ensure good heating performance.
Meijer.com Special Notice on Water Treatment Please read about water quality and filter in user manual. Always shower before you enter your MSpa! Please use test strip to test your water chemistry before each use of the spa, no less than once per week. The pH level must be between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free chlorine between 3 to 5ppm. Too low of a pH level will result in excessive wrinkles and damage to the spa pool as well as corrosion in the motor unit.
Meijer.com Spa Storage Make sure all water is drained from the Spa and control box. This is essential to extend the life of the spa. We recommend the use of a wet/dry vacuum to blow out or suck up water from the Spa pipes and Pump lines. Remove the Filter Cartridge. It is recommended you store the spa in its original package in a warm dry place. NOTE: Make sure all components are completely dry and clean before re-packing. Store safely in dry condition and out of sunlight.
Meijer.com light GFCI GFCI GFCI GFCI GFCI GFCI GFCI GFCI GFCI Error code “F1”“F2” / “F3”“F4” in the display Filter system failure. Do not use the spa. Please contact your country MSpa service center. o SPL, temperature lower than 32 F Please check if there is any water frozen inside the spa and control box, use warm water to melt and o get water temperature higher than 32 F SPH, abnormal high temperature Do not use the spa.
Meijer.com MSpa® products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance Team carefully inspects each unit thoroughly before it leaves our facility. Oriental Recreational Products (Shanghai) Co., Ltd. (ORPC) is pleased to extend this limited warranty coverage to the original purchaser of an MSpa® Product. This warranty is not transferable. The warranty period commences on the original purchase date through 6-12 months accordingly.
Meijer.com Damages caused by or attributable to the following incidents are specially excluded: a. Any damage caused by the operation of the spa with water temperatures outside the range of 0°C-42° C/32°F-107.6°F (Europe/Australia) or 0°C-40°C/32°F-104°F (USA) b. Any damage caused by clogged, dirty or calcified filters c. Any damage that are purely aesthetic and do not hinder the function of the MSpa d.
Meijer.com Country Address/Tel./Fax/E-mail Country E-mail: warranty@goldendesignsinc.com 909-212-5555 USA Canada Address/Tel./Fax/E-mail Go Hot Tubs Ottawa, ON Canada Phone: 1-613-878-9573 E-mail: info@gohottubs.com web: www.gohottubs.
Meijer.com MSpa® Warranty Registration Card Congratulations on purchasing a quality MSpa® product! To get the most value from your investment, please fill in the Warranty Registration Card below. By submitting this form, your warranty will be registered. *Note: Incomplete form will not to be accepted and honored by MSpa.
