Owner Manual
Table Of Contents
JET
31
14
SPA SET-UP
Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground
mat. The heat Preservation Mat prevents heat loss from the bottom of the unit.
1.
2.
3.
2
Spa Inflation
4.1 Plug the spa into the grounded supply socket.
4.2 Press the RESET button on the GFCI, the screen on controller shows numbers.
4.3 Turn the inflation knob to the inflation status <ON> and long press (≥2 minutes) the bubble button on
the controller to start inflating until the yellow section of the manometer is pushed out.
4.4 Stop pressing the bubble button and turn the knob back to <OFF> .
4.
4.3 4.4
Yellow
ON
OFF
BUBBLE
Note:
Before inflation , check whether the manometer cap is
screwed up tight on the valve of pool body. If not, please
tighten and then inflate. After inflation, the manometer
cannot be removed, otherwise the air will be released.