User`s manual

1-2
SUPERSERVER 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F USER'S MANUAL
1-2 Serverboard Features
At the heart of the SuperServer 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F are four
X8DTT-H(F)/HIBX(F)/HIBQ(F) dual processor serverboards, which are based on
Intel's 5520 (North Bridge) + ICH10R (South Bridge) chipset. Below are the main
features of the serverboards. Note that the features on each board are quadrupled
for the server, which includes four nodes.
Processors
Each X8DTT-H(F)/HIBX(F)/HIBQ(F) supports two Intel® 5500/5600 series
processors in LGA 1366 sockets (up to 95w). Please refer to our web site for a
complete listing of supported processors (www.supermicro.com).
Memory
Each X8DTT-H(F)/HIBX(F)/HIBQ(F) has twelve (12) DIMM sockets that can support
up to 192 GB of registered ECC DDR3-1333/1066/800 MHz speed SDRAM, or
48 GB of Unbuffered ECC/Non-ECC DDR3-1333/1066/800 MHz speed memory
(with max. 4 GB of Registered ECC and 2 GB of Unbuffered memory per DIMM
slot.) for a maximum of 192 GB for the system. See Chapter 5 for more details on
installing memory into the system.
Serial ATA
The South Bridge (ICH10R) of the chipset includes a Serial ATA controller for six
Gb/s SATA drives. The hot-swappable SATA drives are connected to a backplane
that provides power, bus termination and confi guration settings. RAID 0, 1, 5 and 10
are supported. Refer to the support area of our web site for procedures on setting
up RAID on your system.
PCI Expansion Slots
Each X8DTT-H(F)/HIBX(F)/HIBQ(F) board has 1x PCI Express 2.0 x16 slot, so four
PCI Express 2.0 x16 slots (for low-profi le expansion cards) are provided in the server.
In the SuperServer 6026TT-HT(R)F/HIBX(R)F/HIBQ(R)F server confi guration, riser
cards have been pre-installed to support low-profi le add-on cards.