User guide

ManageEngine Firewall Analyzer :: User Guide
214
Zoho Corp.
Syngress > set webtrends host-name 10.23.23.2
Syngress > set webtrends port 514
Syngress > set webtrends enable
Configure/Enable SNMP Protocol for Netscreen Firewall device
Using CLI Console:
To add a new SNMP community: (Skip this step, if you have already defined a
community)
set snmp community "<community name>" Read-Only Trap-off version {any | v1 |
v2c}
To enable the SNMP Manager running in Firewall Analyzer to make queries to SNMP
Agent running in the firewall:
set snmp host "<community name>" <Firewall Analyzer IP> [src-interface
<interface through which Firewall Analyzer is connected>]
Example: The following command example defines the IP address '10.5.1.24' as
member of the SNMP community named 'olympia':
set snmp host "olympia" 10.5.1.24 [src-interface inside]
Enable SNMP manageability on the interface through which the SNMP manager in
Firewall Analyzer communicates with the SNMP agent in the NetScreen device.
set interface <interface name> manage snmp
Using Web UI:
To add a new SNMP community: (Skip this step, if you have already defined a
community)
• Log in to the Netscreen web interface
• Go to Configuration > Report Settings > SNMP > New Community
• Enter the following settings:
o Community Name: <community name>
o Permissions:
o Write: (select)
o Trap: (clear)
o Including Traffic Alarms: (clear)
o Version: ANY (select)
o Hosts IP Address/Netmask and Trap Version:<Firewall Analyzer IP
address>
• Click Apply.
To enable the SNMP Manager running in Firewall Analyzer to make queries to SNMP
Agent running in the firewall:
• Go to Configuration > Report Settings > SNMP