Saturn 900 / 945 Series Saturn 900 / 945 Series G52-64661X1
FCC-B Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
Trademark All trademarks are the properties of their respective owners. Intel® and Pentium® are registered trademarks of Intel Corporation. PS/2 and OS ® /2 are registered trademarks of International Business Machines Corporation. W indows ® 95/98/2000/NT/XP are registered trademarks of Microsoft Corporation. Netware® is a registered trademark of Novell, Inc. Award® is a registered trademark of Phoenix Technologies Ltd. AMI® is a registered trademark of American Megatrends Inc. U.S.
Safety Instructions 1. Always read the safety instructions carefully. 2. Keep this User’s Manual for future reference. 3. Keep this equipment away from humidity. 4. Lay this equipment on a reliable flat surface before setting it up. 5. The openings on the enclosure are for air convection hence protects the equipment from overheating. DO NOT COVER THE OPENINGS. 6. Make sure the voltage of the power source and adjust properly 110/220V before connecting the equipment to the power inlet.
Warning: 1. For every changes in powercord’s usage, please use an approved power cord with condition greater or equal to H05VV-F,3G , 0.75mm2. 2. Internal part is hazardous moving parts, please keep fingers and other body parts away. 3. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible. 4. Do not disable the protective earth pin from the plug, the equipment must be connected to an earthed mains socket-outlet.
WEEE Statement vi
vii
viii
CONTENTS FCC-B Radio Frequency Interference Statement................................ii Trademark......................................................................................iii U.S. Patent Numbers......................................................................iii Revision History..............................................................................iii Safety Instructions..........................................................................iv WEEE Statement........................
Chapter 1 Getting Started Congratulations for purchasing MSI® Saturn 900 / 945 Series (MS-6469 / MS-6466). MSI® Saturn 900 / 945 Series is your best Mini-Tower PC choice. ONLY FOR SERVICE PERSONEL For more information about the built-in mainboard's spec ific ation, ple ase re fe r to the mainboard manual in the package.
Saturn 900 / 945 Series System Configuration Front View 1. 2. 3. 4. 5.25” Driver Bay (for ODD) 3.5” Driver Bay (for CR or FDD) Headphone / Speaker (Green) USB 2.0 Ports 5. M icrophone (Pink) 6. Power Button / Power LED 7. Reset Button * This picture is for your reference only and may vary from the different item you installed.
Getting Started Back View 1. 2. 3. 4. 5. 6. Voltage Selector Power Jack Power Switch PS/2 M ouse (Green) PS/2 Keyboard (Purple) Serial Port 7. Parallel Port 8. VGA Port (D-Sub15) 9. LAN Jack (RJ45) 10. USB 2.0 Ports 11. Audio Jacks 12. Expansion Slots * The Input/Output (I/O) part in this picture is for your reference only and may slightly vary from the different mainboard you purchased.
Saturn 900 / 945 Series Internal Placement - Dimension: 190mm (W) x 350mm (H) x 380mm (D) - Minimized screw structure - Multiple ventilation design - Detachable bay housing Expansion Slots Mainboard System Fan ATX Power Supply 3.5” Driver Bay 3.5” Driver Bay 5.
Getting Started Internal Placement - Dimension: 190mm (W) x 350mm (H) x 380mm (D) - Minimized screw structure - Multiple ventilation design - Detachable bay housing Expansion Slots Mainboard System Fan ATX Power Supply 3.5” Driver Bay 3.5” Driver Bay 5.
System Assembly Chapter 2 System Assembly This chapter provides you with the information about system assembly procedures. While doing the installation, be careful in holding the components and follow the installation procedures. Use a grounded wrist strap before handling computer c omp onents . Static elec tri c ity may damage the components. ONLY FOR SERVICE PERSONEL Always unplug the power cord before inserting any add-on card or module.
Saturn 900 / 945 Series Overview The built-in mainboard is designed for MSI® Saturn 900 / 945 Series only. Except the mainboard, the built-in components of the barebone include ATX Power Supply and System Fan. In this chapter, we will show you how to install Optical Disk Drive(ODD), Card Reader(CR), Floppy Disk Drive(FDD), Hard Disk Drive(HDD), PCI Card and PCIExpress Card. Installation Tools Cross type s crewdriv er, c an be used to do mos t of the installation.
System Assembly Checking the Items Before assembling the system, please check the items listed below for basic system operation. W e highly suggest that the users should install retail box CPU heat sink or standard CPU cooler.
Saturn 900 / 945 Series Installation Procedures Removing Covers Unlock the two screws (screw type 3) on the back panel with a screwdriver. Pull the cover (right side) forward. Remove the cover from system.
System Assembly (Continue...) Again, unlock the two screws (screw type 3) on the back panel with a screwdriver. Pull the cover (left side) forward. Remove the cover from system.
Saturn 900 / 945 Series (Continue...) Pull these three hooks with the direction shown on the picture to release the front panel. Down Remove the front panel from system to release all the driver bays. After disassembly.
System Assembly Installing Optical Disk Drive (ODD) Insert the ODD into the 5.25” driver bay. Lock the two screws (screw type 1) to fix the ODD. Turn the system to the other side and lock the other two screws (screw type 1).
Saturn 900 / 945 Series (Continue...) Connect the cable. Connect the power cord.
System Assembly Installing Card Reader (CR) or Floppy Disk Drive (FDD) Insert the CR or FDD into the 3.5” driver bay. Lock the two screws (screw type 1) to fix the CR or FDD. Turn the system to the other side and lock the other two screws (screw type 1). Connect the cable.
Saturn 900 / 945 Series Installing IDE Hard Disk Drvie (HDD) Insert the IDE HDD into the 3.5” driver bay. Lock the two screws (screw type 2) to fix the IDE HDD. Turn the system to the other side and lock the other two screws (screw type 2).
System Assembly (Continue...) Connect the cable. Connect the power cord.
Saturn 900 / 945 Series Installing SATA Hard Disk Drvie (HDD) Insert the SATA HDD into the 3.5” driver bay. Lock the two screws (screw type 2) to fix the SATA HDD. Turn the system to the other side and lock the other two screws (screw type 2).
System Assembly (Continue...) Connect the cable. Connect the SATA power cord.
Saturn 900 / 945 Series Installing PCI Card Unlock the screw (screw type 3) on the lock bracket with a screwdriver. Remove the lock bracket from back panel to release all the expansion slots. Push to remove the metal cover to release the PCI slot.
System Assembly (Continue...) Insert the PCI card vertically into the PCI slot. Lock the screw (screw type 3) on the support bracket.
Saturn 900 / 945 Series Installing PCI Express Card Unlock the screw (screw type 3) on the support bracket and remove the metal cover to release the PCI express slot. Insert the PCI express card vertically into the PCI express slot. Lock the screw (screw type 3) on the support bracket.
System Assembly (Continue...) Restore the lock bracket to back panel to fix all the expansion slots. Lock the screw (screw type 3) on the lock bracket with a screwdriver.
Saturn 900 / 945 Series Restoring Covers Push to remove the plastic cover on the front panel for ODD with fingers carefully. Push to remove the plastic cover on the front panel for CR or FDD with fingers carefully. Restore the front panel to system to fix all the driver bays.
System Assembly (Continue...) Restore the cover (left side) to system. Push the cover backward. Lock the two screws (screw type 3) on the back panel with a screwdriver.
Saturn 900 / 945 Series (Continue...) Again, res tore the cover (right side) to system. Push the cover backward. Lock the two screws (screw type 3) on the back panel with a screwdriver.
System Assembly Complete Installation * These pictures are for your reference only and may vary from the different item you installed.
