Specifications

38
Using BIOS
ACPI Function (Enabled)
This item allows users to enable or disable the ACPI power management function.
ACPI Suspend Type [S3 (STR)]
Use this item to define how your system suspends. When you select S3 (STR), the suspend
mode is suspend to RAM, i.e., the system shuts down with the exception of a refresh
current to the system memory.
Hard Disk Power Down Mode (Disabled)
This setting controls how long a hard disk must be left idle before it spins down. The
default is “Disabled”.
Soft-off by PWR-BTTN (Delay 4 Sec)
Under ACPI (Advanced Configuration and Power management Interface) you can create a
software power down. If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then you have to hold the power
button down for four seconds to cause a software power down.
PWRON After PWR-Fail (Last State)
This item enables your computer to automatically restart or return to its operating status.
Wake-Up by PCI Card (Enabled)
This option allows the activity of the PCI devices to wake up the system from S3 sleep
state.
Power Mangement Setup
This page sets up some parameters for system power management operation.
Select the ACPI state used
for System Suspend.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type [S3 (STR)]
Hard Disk Power Down Mode [Disabled]
Suspend Time Out [Disabled]
Soft-off by PWR-BTTN [On/Off]
PWRON After PWR-Fail [Last State]
Power On by Ring [Disabled]
Wake-Up by PCI Card [Enabled]
Resume On PCI-E PME [Disabled]
Resume On PS2 KeyBoard [Disabled]
Resume On PS2 Mouse [Disabled]
USB KB Wake UP From S3 [Enabled]
Resume by Alarm [Disabled]
Suspend Time Out (Disabled)
This sets the timeout for Suspend mode in minutes. If the time selected passes without any
system activity, the computer will enter power-saving Suspend mode.
Resume On PCI-E PME (Enabled)
This item specifies whether the system will be awakened from power saving modes when
activity or input signal of the specified hardware peripheral or component is detected.
Power On by Ring
An input signal on the serial Ring indicator (RI) line (in other words, and incoming call on
the modem) awakens the system from a soft off state.
: Move
F10: Save
F1: General help

+/-/: Value
Enter : Select
ESC: Exit
F9: Load Default Settings