Specifications

PM-1033
HM86508 Flat Panel Control Module
4
2
Installation
This chapter describes how to install the PM-1033. The layout of
PM-1033 is shown on the next page and the Unpacking
Precautions that you should be careful with are described on the
following page. Also included is the jumpers and connectors
description for this PM-1033.
Hardware Installation :
1. Please read the Unpacking Precautions first before you
install the PM-1033 (see page 6).
2. If your LCD panel is TFT type then skip JP7 and JP8
(default setting of JP8 is for TFT type LCD panel)
3. If your LCD panel is MONO or DSTN type, JP7 must be set
according to the data sheet of the LCD panel (+VEE or –
VEE) then adjust the output of VEE through R19 (Variable
Resistor).
Caution:
don’t make connection to your LCD
panel while you adjust the output of VEE, it may damage
your LCD panel. Measure the voltage with a voltage meter.
4.
Caution:
Don’t set the JP8 to VEE if your LCD panel is
TFT type. It will cause fatal damage to your LCD panel.
5. Select the correct BIOS type for your LCD panel on JP5.
6. Connect your LCD panel cable to CN16 and CRT monitor to
CN15.