User`s manual

3-14
MS-7504 Mainboard
Restore On AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt
occurs. Settings are:
[Power Off] Always leaves the computer in the power off state.
[On] Always leaves the computer in the power on state.
[Last State] Restores the system to the status before power failure or
interrupt occurred.
Wake Up Event Setup
Press <Enter> to enter the sub-menu, and the following screen appears.
Resume From S3 By USB Device
This setting determines whether the system will be awakened from what
power saving modes when input signal of USB devices are detected.
Resume By PCI Device (PME#)
When set to [Enabled], the feature allows your system to be awakened from
the power saving modes through any event on PME (Power Management
Event).
Resume By PCI-E Device
When set to [Enabled], the feature allows your system to be awakened from
the power saving modes through any event on PCIE device.
Resume By Onboard LAN
When set to [Enabled], the feature allows your system to be awakened from
the power saving modes through any event on the onboard LAN.
Resume By RTC Alarm
The field is used to enable or disable the feature of booting up the system on a
scheduled time/ date.
PDF created with pdfFactory Pro trial version www.pdffactory.com