Computer Computer Accessories User Manual

Chapter 3
3-20
Midi Port Address
The field specifies the base I/O port address for the onboard Midi Port.
Available settings: Disabled, 330, 300, 290.
Midi Port IRQ
This will determine which IRQ the midi port will use. Settings: 5, 10.
Init Display First
This item specifies which VGA card is your primary graphics adapter.
Settings: PCI Slot and AGP.
OnChip USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have USB peripherals. Settings: All Enabled, All
Disabled, 1 USB Port, 2 USB Port.
USB Keyboard/Mouse Support
Set to Enabled if you need to use a USB keyboard/mouse in the operating
system that does not support or have any USB driver installed, such as DOS
and SCO Unix. Settings: Enabled, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your hard drive supports block mode (most new drives
do), select Enabled for automatic detection of the optimal number of block
read/writes per sector the drive can support. Settings: Enabled, Disabled.
PWRON After PWR-Fail
This item specifies whether your system will reboot after a power failure
or interrupt occurs. Available settings are:
Off Leaves the computer in the power off state.
On Reboots the computer.
Former-Sts Restores the system to the status before power failure
or interrupt occurred.