User guide

Hardware Setup ▍
MS-S0031
2-5
Hardware Setup ▍
MS-S0031
rear paneL i/o
eSATA Port
The eSATA (External SATA) port is for attaching the eSATA hard drive.
USB 2�0 Port
The USB (Universal Serial Bus) port is for attaching USB devices such as key-
board, mouse, or other USB-compatible devices. Supports data transfer rate up
to 480Mbit/s (Hi-Speed).
USB 3�0 Port
USB 3.0 port is backward-compatible with USB 2.0 devices. It supports data
transfer rate up to 5 Gbit/s (SuperSpeed).
Important
If you want to use a USB 3.0 device, you must use the USB 3.0 cable to con-
nect to the USB 3.0 port.
Please note that lag may occur when users connect the USB keyboard to
the USB 3.0 port and use it under DOS or BIOS Setup.
LAN Port
The standard RJ-45 LAN jack is for connection to the Local Area Network (LAN).
You can connect a network cable to it.
Yellow Green/ Orange
LED Color LED State Condition
Left Yellow Off LAN link is not established.
On (steady) LAN link is established.
On (blinking) The computer is communicating with another computer on the LAN.
Right Green Off 10 Mbit/sec data rate is selected.
On 100 Mbit/sec data rate is selected.
Orange On 1000 Mbit/sec data rate is selected.
▶
▶
▶
•
•
▶
USB 2�0 Port
LAN Port
eSATA Port USB 3�0 Port
LAN Port