Owner's Manual
Hardware Setup
MS-96E3
2-15
Hardware Setup
MS-96E3
Fan Power Connector: CPU_F1, SYS_F1, SYS_F2
The fan power connectors support system cooling fan with +12V. When con-
necting the wire to the connectors, always note that the red wire is the positive
and should be connected to the +12V; the black wire is Ground and should be
connected to GND. If the mainboard has a System Hardware Monitor chipset
onboard, you must use a specially designed fan with speed sensor to take ad-
vantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at processor’s ofcial website or
consult the vendors for proper CPU cooling fan.
PIN SIGNAL
1
2
3
4
GND
+12V
Sensor
Control
1 4
1
4
CompactFlash Socket: CFCARD1
This socket is provided for CompactFlash (CF) cards.