Owner's Manual
BIOS Setup
▍
MS-96D7
3-7
BIOS Setup
▍
MS-96D7
DRAM ECC Enable
This setting enables/disables ECC (Error Correction Code) checking, a meth
-
od of checking the integrity of data in DRAM. ECC provides more elaborate
error detection than parity; ECC can detect multiple-bit errors and can locate
and correct single-bit errors.
PowerNow
This setting enables/disables PowerNow, the speed throttling and power sav
-
ing technology of AMD’s processors. The CPU’s clock speed and VCore are
automatically decreased when the computer is under low load or idle, to save
power and reduce heat/noise.
PowerCap
AMD PowerCap manager gives the ability to put a cap on the P-state level of
a core via the BIOS enabled, helping to deliver consistent, predictable power
consumption of a system.
IDE Conguration
Primary/Secondary/Third/Fourth IDE Master/Slave
[Type] Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type.
Note that the specications of your drive must match with the drive
table. The hard disk will not work properly if you enter improper infor-
mation for this category. If your hard disk drive type is not matched or
listed, you can use [Manual] to dene your own drive type manually.
[LBA/Large Mode] Enabling LBA causes Logical Block Addressing to be used in place of
Cylinders, Heads and Sectors
▶
▶
▶
▶
▶