Owner's Manual

2-10
Hardware Setup ▍
MS-96D7
Hardware Setup ▍
MS-96D7
connector
Serial ATA Connector: SATA1 ~ SATA6
This connector is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
Important
Please do not fold the SATA cable into a 90-degree angle. Otherwise, data loss
may occur during transmission.
Fan Power Connector: SYSFAN1/2/3/4
The fan power connectors support system cooling fan with +12V. When con-
necting the wire to the connectors, always note that the red wire is the positive
and should be connected to the +12V; the black wire is Ground and should be
connected to GND. If the mainboard has a System Hardware Monitor chipset
onboard, you must use a specially designed fan with speed sensor to take ad-
vantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at processor’s ofcial website or
consult the vendors for proper CPU cooling fan.
PIN SIGNAL
1
2
3
4
GND
+12V
Sensor
Control
4 1
SYSFAN1
4
1
SYSFAN2/3/4