Specifications
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Hardware Setup
- Quick Components Guide
- CPU (Central Processing Unit)
- Memory
- Power Supply
- Back Panel
- Connectors
- Floppy Disk Drive Connector: FDD1
- ATA133 Hard Disk Connectors: IDE1 & IDE2
- Serial ATA Connectors: SATA1, SATA2
- BIOS Password Clear: JPWD1
- Fan Power Connectors: CPU_FAN1, SYS_FAN1
- Front USB Connectors: JUSB1, JUSB2
- SPDIF-Out Connector: SPDOUT1
- Front Panel Audio Connector: JAUD1
- BIOS Flash Write Protection: JWP1
- IEEE 1394 Connectors: J1394_1
- Front Panel Connectors: JFP1
- Jumpers
- Slots
- Chapter 3 BIOS Setup
3-18
MS-7293 Mainboard
Primary Graphics Adapter
This setting specifies which graphics card is your primary graphics adapter.
PCI Latency Timer (CLK)
This item controls how long each PCI device can hold the bus before another takes
over. When set to higher values, every PCI device can conduct transactions for a
longer time and thus improve the effective PCI bandwidth. For better PCI performance,
you should set the item to higher values.
** PCI Express relative items **
Maximum Payload Size
This item allows you to set the PCI Express Maximum payload size per time .
PNP/PCI Configurations
This section describes configuring the PCI bus system and PnP (Plug & Play) feature.
PCI, or Peripheral Component Interconnect, is a system which allows I/O devices to
operate at speeds nearing the speed the CPU itself uses when communicating with
its special components. This section covers some very technical items and it is
strongly recommended that only experienced users should make any changes to the
default settings.