Specifications
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Hardware Setup
- Quick Components Guide
- CPU (Central Processing Unit)
- Memory
- Power Supply
- Back Panel
- Connectors
- Floppy Disk Drive Connector: FDD1
- ATA133 Hard Disk Connectors: IDE1 & IDE2
- Serial ATA Connectors: SATA1, SATA2
- BIOS Password Clear: JPWD1
- Fan Power Connectors: CPU_FAN1, SYS_FAN1
- Front USB Connectors: JUSB1, JUSB2
- SPDIF-Out Connector: SPDOUT1
- Front Panel Audio Connector: JAUD1
- BIOS Flash Write Protection: JWP1
- IEEE 1394 Connectors: J1394_1
- Front Panel Connectors: JFP1
- Jumpers
- Slots
- Chapter 3 BIOS Setup
3-14
MS-7293 Mainboard
LAN Controller
It allows you to enable/ disable the LAN controller.
Lan Boot ROM
This item is used to decide whether to invoke the Boot ROM of the Onboard LAN
Chip.
Onboard IEEE1394 Controller
This item allows you to enable/disable the onboard IEEE1394 controller.
Super IO Device
Press <Enter> to enter the sub-menu:
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select [Disabled] in this field.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port.
USB Device Setting
Press <Enter> to enter the sub-menu:
USB 1.0/ 2.0 Controller
These items allow you to enable/ disable USB 1.0/ 2.0 controller.
USB Operation Mode
It lets you select the operation mode for USB.
USB Keyboard Function
Select Enabled if you use the USB keyboard.
USB Mouse Function
Select Enabled if you use the USB Mouse.
USB Storage Function
Select Enabled if you use the USB Storage device.