Specifications
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Hardware Setup
- Quick Components Guide
- CPU (Central Processing Unit)
- Memory
- Power Supply
- Back Panel
- Connectors
- Floppy Disk Drive Connector: FDD1
- ATA133 Hard Disk Connectors: IDE1 & IDE2
- Serial ATA Connectors: SATA1, SATA2
- BIOS Password Clear: JPWD1
- Fan Power Connectors: CPU_FAN1, SYS_FAN1
- Front USB Connectors: JUSB1, JUSB2
- SPDIF-Out Connector: SPDOUT1
- Front Panel Audio Connector: JAUD1
- BIOS Flash Write Protection: JWP1
- IEEE 1394 Connectors: J1394_1
- Front Panel Connectors: JFP1
- Jumpers
- Slots
- Chapter 3 BIOS Setup
3-13
BIOS Setup
Integrated Peripherals
VIA OnChip IDE Device
Press <Enter> to enter the sub-menu:
SATA Controller
It allows you to enable/ disable the SATA controller.
SATA Controller Mode
It lets you select the SATA controller mode.
IDE DMA transfer access
Setting to [Enabled] will open DMA bus master and execute DMA action in DOS,
which will make the data transferring faster.
OnChip IDE Channel 0/1
These allow you to enable/disable the IDE channel 0/1.
IDE Prefetch Mode
The onboard IDE drive interfaces support IDE prefetching, for faster drive
accesses. When you install a primary and/or secondary add-in IDE interface,
set this option to Disabled if the interface does not support prefetching.
VIA OnChip PCI Device
Press <Enter> to enter the sub-menu:
Azalia HDA Controller
It allows you to enable/ disable the Azalia HDA controller.