Specifications
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Hardware Setup
- Quick Components Guide
- CPU (Central Processing Unit)
- Memory
- Power Supply
- Back Panel
- Connectors
- Floppy Disk Drive Connector: FDD1
- ATA133 Hard Disk Connectors: IDE1 & IDE2
- Serial ATA Connectors: SATA1, SATA2
- BIOS Password Clear: JPWD1
- Fan Power Connectors: CPU_FAN1, SYS_FAN1
- Front USB Connectors: JUSB1, JUSB2
- SPDIF-Out Connector: SPDOUT1
- Front Panel Audio Connector: JAUD1
- BIOS Flash Write Protection: JWP1
- IEEE 1394 Connectors: J1394_1
- Front Panel Connectors: JFP1
- Jumpers
- Slots
- Chapter 3 BIOS Setup
2-9
Hardware Setup
Back Panel
Serial Port Connector
The serial port is a 16550A high speed communications port that sends/ receives 16
bytes FIFOs. You can attach a serial mouse or other serial devices directly to the
connector.
IEEE 1394 Port
The 1394 port on the back panel provides connection to 1394 devices.
USB Connectors
The OHCI (Open Host Controller Interface) Universal Serial Bus root is for attaching
USB devices such as keyboard, mouse, or other USB-compatible devices.
LAN (RJ-45) Jack
The standard RJ-45 jack is for connection to single Local Area Network (LAN). You
can connect a network cable to it.
Link IndicatorActivity Indicator
LED Color LED State Condition
Off LAN link is not established.
Left Orange On (steady state) LAN link is established.
On (brighter & pulsing)The computer is communicating with another computer on the LAN.
Green Off 10 Mbit/sec data rate is selected.
Right On 100 Mbit/sec data rate is selected.
Orange On 1000 Mbit/sec data rate is selected.
USB Ports
L-In
1394 Port
LAN
Serial Port
RS-Out
SS-Out
CS-Out
L-Out
Mic
SPDIF-Out