Specifications
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Hardware Setup
- Quick Components Guide
- CPU (Central Processing Unit)
- Memory
- Power Supply
- Back Panel
- Connectors
- Floppy Disk Drive Connector: FDD1
- ATA133 Hard Disk Connectors: IDE1 & IDE2
- Serial ATA Connectors: SATA1, SATA2
- BIOS Password Clear: JPWD1
- Fan Power Connectors: CPU_FAN1, SYS_FAN1
- Front USB Connectors: JUSB1, JUSB2
- SPDIF-Out Connector: SPDOUT1
- Front Panel Audio Connector: JAUD1
- BIOS Flash Write Protection: JWP1
- IEEE 1394 Connectors: J1394_1
- Front Panel Connectors: JFP1
- Jumpers
- Slots
- Chapter 3 BIOS Setup
MS-7293 Mainboard
2-4
2. Remove the cap from lever hinge
side (as the arrow shows).
1. The CPU has a plastic cap on it to
protect the contact from damage.
Before you install the CPU, always
cover it to protect the socket pin.
3. The pins of socket reveal.
CPU & Cooler Installation
When you are installing the CPU, make sure the CPU has a cooler at-
tached on the top to prevent overheating. If you do not have the cooler, contact
your dealer to purchase and install them before turning on the computer. Meanwhile,
do not forget to apply some silicon heat transfer compound on CPU before installing
the heat sink/cooler fan for better heat dispersion.
Follow the steps below to install the CPU & cooler correctly. Wrong installation
will cause the damage of your CPU & mainboard.
4. Open the load lever.