Technical information

Polycom CMA System Release Notes
Version 5.3
38
UI SSGSE-7481
SSGSE-7480
5.0 On the Network Device >
Monitor View page, the
Gatekeeper registration and
Device Managed status may be
incorrect for an RMX system.
Check the Device Status of the
RMX for the correct status.
UI SSGSE-7421 If there is an IP address conflict
when adding a Polycom VBP
device (i.e., the device’s IP
address conflicts with another
device already registered to the
Polycom CMA system), the
administrator cannot add the
VBP. However, the UI shows a
generic error message instead of
an accurate one stating that
there is an IP address conflict.
None, except to resolve the IP
conflict.
UI SSGSE-7320 5.0 When a registered MCU has
calls on it, there is no far site call
information in the View Details
dialog box.
None
UI SSGSE-7311 4.1.4 Configuring a user interface
timeout value of 999999 (or
similar) locks all users out of the
system.
None
UI SSGSE-7259 5.0 For a user with multiple video
devices, the Polycom CMA
Desktop device cannot be
selected as the preferred device.
Edit the device to make it the
preferred device.
UI SSGSE-7138 5.0 For some pop-up messages on
the Polycom CMA system,
selecting OK does not close the
popup.
Click the red X to close the
popup message.
UI SSGSE-6796 5.0 The Conference Management
page may not automatically
refresh and show the correct
status of a long duration call if
the call disconnects by itself,
especially if the disconnect
occurs at or after midnight.
Click Refresh to manually
refresh the page.
Category
Issue #
Found in
Release Description Workaround