Specifications

Step 5: Installing VP-40 Capture Card

Our capture card is proprietary and will only work with our DVR chip. Install the capture card into an

available PCI slot. Once the system boots the VPON firmware will automatically detect how many

capture cards are in the PCI slots.

Step 6: Installing the hard drives

For a single drive make sure the jumper settings is set on primary. Attach that with any ordinary IDE

cable onto the secondary IDE channel. For dual drives make sure one hard drive is set on primary and the

secondary on slave. Attach those to the IDE cable and plug into the secondary IDE channel. The max hard

drive size supported is 500GB each. For a total of 1TB.

Note: When VP-100 based DVR is working for the first time, the system will erase the data in the hard

disk. If there is important information in the hard disk, please remember to backup the data in another

storage before the hard disk is used in the VP-100 based DVR.

Step 7: Installing the VP-100 DVR module

The VP-100 DVR module sits on the primary IDE slot on the motherboard. If attaching a CD-RW to your

unit then put the VP-100 DVR module in the middle of the yellow IDE cable included. And then put the

end of the yellow IDE cable to the CD-RW and the other end to the primary IDE channel. The yellow

IDE cable must be used with the VP-100 DVR module and not any generic IDE cable. Then attach the

power connector from the VP-100 DVR module to a free lead from the power supply.

Step 8 : Installing I/O Card (Optional)

GPI and GPO are use for alarm inputs and outputs control. Please refer to chapter 3 for more detail

information.

VP-40 Capture card

DVR module