Specifications

2-11
Hardware Setup
Connectors
FDD1
The mainboard provides connectors to connect to FDD, IDE HDD, case,
modem, LAN, USB ports, and CPU/system fans.
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive connector that
supports 360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
Hard Disk Connectors: PRIMAR1 & SECON1
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/
100 controller that provides PIO mode 0~4, Bus Master, and Ultra DMA33/
66/100 function. You can connect up to four hard disk drives, CD-ROM,
120MB Floppy (reserved for future BIOS) and other devices. These connec-
tors support the provided IDE hard disk cable.
MSI Reminds You...
If you install two hard disks on cable, you must configure the
second drive to Slave mode by setting its jumper. Refer to the
hard disk documentation supplied by hard disk vendors for
jumper setting instructions.
PRIMAR1
SECON1
PRIMAR1 (Primary IDE Connector)
The first hard drive should always be connected to PRIMAR1.
PRIMAR1 can connect a Master and a Slave drive. You must configure
second hard drive to Slave mode by setting the jumper accordingly.
SECON1 (Secondary IDE Connector)
SECON1 can also connect a Master and a Slave drive.