User Manual
Table Of Contents
- Quick Start
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- CPU Socket
- DIMM Slots
- PCI_E1~5: PCIe Expansion Slots
- JFP1, JFP2: Front Panel Connectors
- M2_1~3: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JAUD1: Front Audio Connector
- JTBT1: Thunderbolt Add-on Card Connector
- CPU_PWR1~2, ATX_PWR1, PCIE_PWR1: Power Connectors
- JDASH1 : Tuning Controller connector
- JCI1: Chassis Intrusion Connector
- JUSB4: USB 3.2 Gen 2 Type-C Connector
- JUSB3: USB 3.2 Gen 1 Connector
- JUSB1~2: USB 2.0 Connectors
- JTPM1: TPM Module Connector
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~6: Fan Connectors
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- JRGB1: RGB LED connector
- JRAINBOW1~2: Addressable RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- Onboard LEDs
- Installing OS, Drivers & MSI Center
- UEFI BIOS
- RAID Configuration
- Intel® Optane™ Memory Configuration
- Troubleshooting
41
Overview of Components
JBAT1: Clear CMOS (Reset BIOS) Jumper
There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Keep Data
(default)
Clear CMOS/
Reset BIOS
Resetting BIOS to default values
1. Power off the computer and unplug the power cord.
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and Power on the computer.