User Manual
Table Of Contents
- Quick Start
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- CPU Socket
- DIMM Slots
- PCI_E1~5: PCIe Expansion Slots
- JFP1, JFP2: Front Panel Connectors
- M2_1~3: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JAUD1: Front Audio Connector
- JTBT1: Thunderbolt Add-on Card Connector
- CPU_PWR1~2, ATX_PWR1, PCIE_PWR1: Power Connectors
- JDASH1 : Tuning Controller connector
- JCI1: Chassis Intrusion Connector
- JUSB4: USB 3.2 Gen 2 Type-C Connector
- JUSB3: USB 3.2 Gen 1 Connector
- JUSB1~2: USB 2.0 Connectors
- JTPM1: TPM Module Connector
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~6: Fan Connectors
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- JRGB1: RGB LED connector
- JRAINBOW1~2: Addressable RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- Onboard LEDs
- Installing OS, Drivers & MSI Center
- UEFI BIOS
- RAID Configuration
- Intel® Optane™ Memory Configuration
- Troubleshooting
3
Quick Start
Case stand-off notification
Before installing the motherboard into the case, install first the necessary mounting
stand-off required for a motherboard on the mounting plate in the case.
To prevent damage to the motherboard, any unnecessary mounting stand-off between
the motherboard circuits and the computer case is prohibited. The Case standoff keep
out zone signs will be marked on the backside of motherboard (as shown below) to
serve as a warning to user.