User's Manual
Table Of Contents
- Quick Start
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- Processor Socket
- DIMM Slots
- PCI_E1~4: PCIe Expansion Slots
- M2_1~4: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JFP1, JFP2: Front Panel Connectors
- JAUD1: Front Audio Connector
- CPU_PWR1~2, ATX_PWR1, PCIE_PWR1: Power Connectors
- JUSB3~4: USB 2.0 Connectors
- JUSB1: USB 3.2 Gen 2 10Gbps Type-C Connector
- JUSB2: USB 3.2 Gen 1 5Gbps Connector
- JTPM1: TPM Module Connector
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~6: Fan Connectors
- JCI1: Chassis Intrusion Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- POWER1, RESET1: Power Button, Reset Button
- JRGB1: RGB LED connector
- JRAINBOW1~2: Addressable RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- Onboard LEDs
- Installing OS, Drivers & Utilities
- UEFI BIOS
- AMD RAID Configuration
- Troubleshooting
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~6: Fan Connectors
- CPU_PWR1~2, ATX_PWR1, PCIE_PWR1: Power Connectors
- DIMM Slots
- JAUD1: Front Audio Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- JCI1: Chassis Intrusion Connector
- JCORSAIR1: CORSAIR Connector
- JFP1, JFP2: Front Panel Connectors
- JRAINBOW1~2: Addressable RGB LED connectors
- JRGB1: RGB LED connector
- JTPM1: TPM Module Connector
- JUSB1: USB 3.2 Gen 2 10Gbps Type-C Connector
- JUSB2: USB 3.2 Gen 1 5Gbps Connector
- JUSB3~4: USB 2.0 Connectors
- LED_SW1: EZ LED Control
- M2_1~4: M.2 Slots (Key M)
- PCI_E1~4: PCIe Expansion Slots
- POWER1, RESET1: Power Button, Reset Button
- Processor Socket
- SATA1~6: SATA 6Gb/s Connectors
45
Overview of Components
JBAT1: Clear CMOS (Reset BIOS) Jumper
There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Keep Data
(default)
Clear CMOS/
Reset BIOS
Resetting BIOS to default values
1. Power off the computer and unplug the power cord.
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and Power on the computer.
POWER1, RESET1: Power Button, Reset Button
The Power / Reset button allows you to power on / reset the computer.
Power button
Reset
Reset button