System information

68
 Using STM
Provide the appropriate information about the array you want to monitor. If you
are unsure about a value, do not change the value from the default.
• Status: Select On
• User Name: Type the user name used to access the provider
• Password: Type the password used to access the provider
• Provider IP Address: Type the IP address of the server where the
provider is installed
• Serial Number: Type the array identifier (the serial number of ClariiON -
Ex: ClariiON+APM#######)
5. Click Save to save the configuration and push it out to the agent to begin
monitoring the array.
Notes: Click Test to test the connectivity between the agent and provider, and if
successful, display the identifiers from the arrays configured in the provider. Note
you must have entered the username, password and provider IP address before
pressing this .
You can also configure arrays on the Devices page (Settings > Devices).