Installation Guide

5. Each piece of slate should be rmly pressed into the adhesive to secure a

good bond.

After all slate tiles is set in place – allow at least 24-36 hours depending on

weather conditions, for drying before grouting joints.

7. Slate tile can be easily cut with a wet saw using a diamond blade

GROUTING AND CLEANING

1.Have all equipment and material clean. Clean all joints and surface of slate.

Applying clear sealer or enhancer is recommended on slate before grouting,

so that the grout color does not penetrate the slate tiles. Use clear sealer or

enhancer as a grout release to insure a clean surface.

Using a Clear Sealer or Enhancer is a personal choice.

2. Add water slowly while mixing to get the texture of damp sand mix grout

according to the manufacturer specs, and apply with a grout oat to press

grout deeply between the joints. Mix only enough grout to be used in about

30 minutes or diculty will result in hardening in the pail.

3. Apply mix to joints with a grout oat making certain joint is completely

lled with mix.