Use and Care Manual

5 HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
Installation
1
Preparing the countertop
□ Place the template (B) on the countertop. Ensure the
template (B) is centered on the counter so that it is parallel
to the counter edge and that the installation hole will not
interfere with the structure of the cabinet.
□ Tape the template (B) to the countertop to keep it in place
while tracing the perforated line on the template (B) with a
pencil. Once traced, your line will be left on the surface.
2
Cutting the installation hole
□ Drill a pilot hole to insert the blade of your jigsaw.
□ Cut the countertop opening. Use the appropriate
cutting tool for the surface you are cutting
and cut along the inside of the template line.
Us
e
this line
fo
r FLUS H MOU NT C UT.
Cutout for Under Mount Installation
3
Drilling holes for the clips
□ On the underside of the counter, mark the location of the
holes for the clips (AA). These holes should be equally
spaced around the perimeter of the cutout.
□ Using an electric drill with a 11 mm drill bit, drill each hole
so that it is 11 mm in diamter and 14 mm deep.
□ Insert the plastic caps (BB) from each of the clips (AA) into
each of the installation holes.