Service manual

8258I N/B Maintenance

1. To install the DDR2, match the DDR2's notched part with the socket's projected part and firmly insert the

SO-DIMM into the socket at 20-degree angle. Then push down until the retaining clips lock the DDR2 into

position.

2. Replace the CPU cover and secure with eight screws. (Refer to step 3 of section 2.3.3 Reassembly)

3. Replace the battery pack. (See section 2.3.1 Reassembly)

Disassembly

1. Carefully put the notebook upside down. Remove the battery pack. (See section 2.3.1 Disassembly)

2. Remove eight screws fastening the CPU cover. (Refer to step 2 of section 2.3.3 Disassembly)

2.3.6 DDR2-SDRAM

3. Pull the retaining clips outwards () and remove the SO-DIMM (). (Figure 2-11)

Reassembly

Figure 2-11 Remove the SO-DIMM

MiTac Secret

Confidential Document