Specifications

En-32

MS-7758 Manboard

tWTR

Determnes mnmum tme nterval between the end of wrte data burst and the start

of a column-read command; allows I/O gatng to overdrve sense amples before

read command starts.

tRRD

Speces the actve-to-actve delay of derent banks.

tRTP

Tme nterval between a read and a precharge command.

tFAW

Ths tem s used to set the tFAW (four actvate wndow delay) tmng.

tWCL

Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.

Advanced Channel 1/ 2 Tmng Conguraton

Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng

for each channel.

GT OverClockng

Ths tem allows you to enable/ dsable the overclockng of ntegrated graphcs.

GT Rato

Ths settng controls the rato of ntegrated graphcs frequency to enable the ntegrated

graphcs to run at derent frequency combnatons.

Adjusted GT Frequency

It shows the GPU frequency. Read-only.

Spread Spectrum

Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng

clock generator pulses.

Important

If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system

stablty and performance. But f you are plagued by EMI, select the value of Spread

Spectrum for EMI reducton.

The greater the Spread Spectrum value s, the greater the EMI s reduced, and the

system wll become less stable. For the most sutable Spread Spectrum value, please

consult your local EMI regulaton.

Remember to dsable Spread Spectrum f you are overclockng because even a slght

jtter can ntroduce a temporary boost n clock speed whch may just cause your

overclocked processor to lock up.

CPU Core Voltage/ DRAM Voltage.

These tems are used to adjust the voltage of CPU and Memory.

Current CPU Core Voltage/ Current DRAM Voltage

These tems show current CPU/ DRAM voltage. Read-only.

▶

•

▶