Instruction manual

3-23
BIOS Setup
PNP/PCI Configurations
Primary Graphic’s Adapter
This setting specifies which graphic card is your primary graphics adapter.
Setting options are:
[AGP] The system initializes the installed AGP card first. If an AGP
card is not available, it will initialize the PCI VGA card.
[PCI] The system initializes the installed PCI VGA card first. If a PCI
VGA card is not available, it will initialize the AGP card.
PCI Latency Timer (CLK)
This item controls how long each PCI device can hold the bus before another
takes over. When set to higher values, every PCI device can conduct transac-
tions for a longer time and thus improve the effective PCI bandwidth. For better
PCI performance, you should set the item to higher values.
IRQ Resources
The items are adjustable only when Resources Controlled By is set to Manual.
Press <Enter> and you will enter the sub-menu of the items. IRQ Resources list
IRQ 3/4/5/7/9/10/11/12/14/15 for users to set each IRQ a type depending on the
type of device using the IRQ. Settings are:
[PCI Device] For Plug & Play compatible devices designed for PCI
bus architecture.
[Reserved] The IRQ will be reserved for further request.