User`s manual

3-17
BIOS Setup
Restore on AC Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Setting options:
[Off] Leaves the computer in the power off state.
[On] Leaves the computer in the power on state.
[Last State] Restores the system to the previous status before power
failure or interrupt occurred.
Wakeup Event Setup
Press <Enter> and the following sub-menu appears.
Resume by PCI-E Device
The item allows the activity of the PCI-E device to wake up the system. Setting
options: [Disabled], [Enabled].
Resume by PCI Device (PME#)
When setting to [Enabled], this setting allows your system to be awakened from
the power saving modes through any event on PME (Power Management Event).
Setting options: [Disabled], [Enabled].
Resume From S3 by USB
The item allows the activity of the USB device to wake up the system from S3
(Suspend to RAM) sleep state. Setting options: [Disabled], [Enabled].
Resume by RTC Alarm
This is used to enable or disable the feature of booting up the system on a
scheduled time/date from the S3, S4, and S5 power off state. Setting options:
[Disabled], [Enabled].
Suspend Time Out (Minute)
If system activity is not detected for the length of time specified in this field, all devices
except CPU will be shut off. Setting options: [Disabled], [1 Min], [2 Min], [4 Min], [8
Min], [10 Min], [20 Min], [30 Min], [40 Min], [1 Hour].
Power Button Function
This feature sets the function of the power button. Setting options:
[Power Off] The power button functions as normal power off button.
[Suspend] When you press the power button, the computer enters the suspend/
sleep mode, but if the button is pressed for more than four seconds,
the computer is turned off.