User`s manual

2-25
Hardware Setup
2.Use the external cable to connect the two graphics cards. The cable is
attached from the CrossFire Ready graphics card’s DVI connector to the CrossFire
Edition high density input connector (DMS). Then connectting a monitor to the left DVI
connector.
DVI connector
DMS connector
DVI connector (connectting
to the monitor)
The CrossFire Edition
graphics card.
The CrossFire Ready
graphics card.
Important
1. Mainboard photos shown in this section are for demonstration only. The ap-
pearance of your mainboard may vary depending on the model you purchase.
2. Only Windows
®
XP with Service Pack 2 (SP2)& Windows
®
XP Profes
-sional x64 Edition support the CrossFire function.
3. Always install the CrossFire Edition graphics card in the Primary PCIEX16
slot (PEG1), and install the CrossFire Ready graphics card in the Second-
ary PCIEX16 slot (PEG2) to make the CrossFire technology functions
properly.