Specifications

6
Step 5: Installing VP-2x Capture Card
Our capture card is proprietary and will only work with our DVR firmware. Install the capture card into
an available PCI slot. Once the system boots the VPON firmware will automatically detect how many
capture cards are in the PCI slots.
Step 6: Installing the hard drives
For a single drive make sure the jumper settings is set on primary. Attach that with any ordinary IDE
cable onto the secondary IDE channel.
For dual drives make sure one hard drive is set on primary and the secondary on slave. Attach those to the
IDE cable and plug into the secondary IDE channel. You can also install 2 HDD on primary IDE after
completion firmware installation. Please refer to Step 7.
The max hard drive size supported is 500GB each. For a total of 2TB including firmware space.
Step 7 : Installing CD-ROM, Keyboard and mouse
Install a CD-ROM for installing Firmware from CD. After installing Firmware you can remove the
CD-ROM and change to Hard disk for extend your storage size (max 4 hard disks total system).
Or Installing the VP-20 DOM module
The VP-20 DOM module sits on the primary IDE slot on the motherboard. If attaching a CD-RW to your
unit then put the VP-20 DOM module in the middle of the yellow IDE cable included. And then put the
end of the yellow IDE cable to the CD-RW and the other end to the primary IDE channel. The yellow
IDE cable must be used with the VP-20 DOM module and not any generic IDE cable. Then attach the
power connector from the VP-20 DOM module to a free lead from the power supply.
Note: DOM module (Model: VP-20) is an optional device, if you need it please contact us. When install
DOM on primary IDE, you can NOT install HDD on the same IDE slot. This makes totally 2*HDD per
PC DVR system.
Capture card