Instruction manual

3-21
BIOS Setup
Wake Up On PME, USB Wakeup From S3
These fields specify whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected. Settings: Enabled, Disabled.
CPU THRM-Throttling
The item allows you to specify the CPU speed (at percentage) to which it will
slow down when the CPU reaches the predetermined overheat temperature.
Settings range from 12.5% to 87.5% at 12.5% increment.
Resume by RTC Alarm
The field is used to enable or disable the feature of booting up the system on
a scheduled time/date.
Date (of Month) Alarm
The field specifies the date for Resume by Alarm. Settings: 0~31.
Time (hh:mm:ss) Alarm
The field specifies the time for Resume by Alarm. Format is <hour>
<minute><second>.
POWER ON Function
This controls which part on the PS/2 mouse or keyboard can power on the
system.Settings: Password, Hot KEY, Mouse Left, Mouse Right, Any Key,
BUTTON ONLY, Keyboard 98.
KB Power ON Password
If POWER ON Function is set to Password, then you can set a password in the
filed for the PS/2 keyboard to power on the system.
Hot Key Power ON
If POWER ON Function is set to HOT Key, then you can set a password in the
filed for the PS/2 keyboard to power on the system. Settings: Ctrl-F1 through
Ctrl-F12.
Power Again
This item specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
Power Off Leaves the computer in the power off state.
Power On Leaves the computer in power on state.