Instruction manual

B-8
845PE Max2 ATX Mainboard
Installing Drivers During Windows Me/98 Installation
The following details the installation of the MBUltra133 drivers while
installing Windows Me/98 (with the MBUltra133 controller card already in
place). If you’re installing the MBUltra133 drivers on a system with Me already
installed, see “Installing Drivers with Existing Windows Me/98 System.”
1. Install Windows Me/98 fully.
2. After installation, go the “Start” menu and choose “Settings.”
3. From the “Settings” menu, choose “Control Panel.”
4. In the “Control Panel” window, double-click on the “System” icon.
5. In the “System” window, choose the “Device Manager” tab.
6. In the hierarchical display under “Other Devices” is a listing for “PCI
Mass Storage Controller.” Choose it and then press the “Properties”
button.
7. Choose the “Driver” tab in the “Properties” window, choose “Update
Driver,” and then press “Next.”
8. Choose “Specify the location of the driver (Advanced),” then press
“Next”.
9. Insert the MBUltra133 Driver diskette into the A: drive.
10. Choose “Specify a Location,” and then type “A:\WIN9X-ME” in the
text box.
11. Press the “Next” button. A message informing you that Windows Me/
98 has found “Win9x-ME Promise MBUltra133 IDE Controller” should
appear.
12. Press “Next,” then “Finish,” then “Yes” when asked if you want to
restart your computer. Be sure to remove the diskette from drive A:.
Installing Drivers with Existing Windows Me/98 System
The following section details the installation of MBUltra133 drivers on
a system that has Windows Me/98 already installed and running. If you’re
installing the MBUltra133 drivers on a system during an installation of Win-
dows Me, see “Installing Drivers During Windows Me/98 Installation.”
1. After installing the MBUltra133 controller card and configuring the
hard drives, power up the system and boot.
2. The “Add New Hardware Wizard” will appear, informing you that it