Instruction manual

Installing ATA133 RAID Driver
B-7
Installing Drivers with Existing Windows NT 4.0
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel” from the “Settings” menu.
3. Double-click on the “SCSI Adapters” icon, which generates the “SCSI
Adapters” dialog box.
4. Choose “Drivers,” and then press “Add.”
5. In the “Install Drivers” dialog box, press “Have Disk…”
6. When the “Install From Disk” appears, insert the “MBUltra133 Driver”
diskette in drive A:.
7. Type “A:\NT4” in the text box, then choose “OK.”
8. When the “Install Driver” dialog box appears, select “WinNT Prom-
ise MBUltra133 IDE Controller” and then press “OK.”
9. When the “Select SCSI Adapter Option” dialog box appears, press
“Install.”
10. After a successful installation, the “SCSI Adapter Setup” box will
show that the “WinNT Promise MBUltra133 IDE Controller” driver
has been installed.
11. Power off your system, and then attach your hard drive(s) (see page 4
for more details) to the MBUltra133 controller card.
now load all device files and then continue the Windows NT
installation.
8. After a successful installation, the “SCSI Adapter Setup” box will
show that the “WinNT Promise MBUltra133 IDE Controller” driver
has been installed.
MSI Reminds You...
If you wish to use your current bootable drive with the Win-
dows NT4 operating system on the MBUltra133 , perform the
steps below while the boot drive is still attached to your exist-
ing onboard IDE controller. Do not attach any drives to your
MBUltra133 until the steps below are complete.