Instruction manual

B-6
845PE Max2 ATX Mainboard
Installing Drivers During New Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a. Floppy install: boot the system with the Windows NT instal-
lation diskettes.
b. Floppyless install: boot from floppy and type “WINNT /B”.
After files have been copied, the system will reboot. On the
reboot, press the “F6” key when the message “Setup is in-
specting your computer’s hardware configuration…”
appears.
c. CD-ROM disk install: boot from the CD-ROM disk and press
the “F6” key when the message “Setup is inspecting your
computer’s hardware configuration…” appears.
2. When the “Windows NT Setup” window is generated, press “S” to
Specify an Additional Device(s).
3. Use “↑” or “↓” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology driver diskette into drive A: and
press the “Enter” key.
5. Choose “WinNT Promise MBUltra133 IDE Controller” from the list
appearing on screen, then press the “Enter” key.
6. The Windows NT Setup screen will appear again saying “Setup will
load support for the following mass storage devices:” The list will
include “WinNT Promise MBUltra133 IDE Controller”.
NOTE: If you need to specify any additional devices to be installed, do
so at this time. Once all devices are specified, continue to the next step –
7. From the Windows NT Setup screen, press the Enter key. Setup will
MSI Reminds You...
If you will be moving the boot drive containing the existing
Windows XP operating system to the MBUltra133 card, the
MBUltra133 driver MUST be loaded on to this hard drive
while it is still attached to your existing hard drive
controller. Do not attach this drive or any other hard drive
to the MBUltra133 controller card before completing this
step.