Instruction manual

Installing ATA133 RAID Driver
B-5
Installing Driver in existing Windows XP System
After installing the MBUltra133 card and rebooting your system, Win-
dows XP setup will show a “Found New Hardware” dialog box. Under Win-
dows XP, “Mass Storage Controller” will be displayed.
1. In the A:\ drive, insert the MBUltra133 driver diskette.
2. Choose “Install the software automatically” and then press the “En-
ter” key.
3. Choose “WinXP Promise MBUltra133 IDE Controller” from the list
that appears on screen, and then press the “Enter” key.
4. If using a driver that has not been digitally signed by Microsoft, you
will be asked if you want to continue the installation. Click on “Con-
tinue anyway”.
5. When the New Hardware Wizard has finished installing the Promise
Ultra ATA 133 software, click on “Finish”.
Confirming Windows XP Installation
1. From Windows XP, open the Control Panel from “My Computer”.
2. Click on “Performance and maintenance”.
3. Click on the “System” icon.
4. Choose the “Hardware” tab, and then click the “Device Manager”
tab.
5. Click the “+” in front of “SCSI controllers”. “WinXP Promise
MBUltra133 IDE Controller” should appear.
6. The Windows XP Setup screen will appear again saying “Setup will
load support for the following mass storage devices:” The list will
include “WinXP Promise MBUltra133 IDE Controller”.
NOTE: If you need to specify any additional devices to be installed,
do so at this time. Once all devices are specified, continue to the next
step –
7. From the Windows XP Setup screen, press the Enter key. Setup will
now load all device files and then continue the Windows XP