Instruction manual

Installing ATA133 RAID Driver
B-3
MSI Reminds You...
If you will be moving the boot drive containing the existing
Windows 2000 operating system to the MBUltra133 card, the
MBUltra133 driver MUST be loaded on to this hard drive while
it is still attached to your existing hard drive controller. Never
attach this drive or any other hard drive to the MBUltra133
controller card before completing this step.
Confirming Windows 2000 Installation
1. From Windows 2000, open the Control Panel from “My Computer”
followed by the System icon.
2. Choose the “Hardware” tab, and then click the “Device Manager”
tab.
3. Click the “+” in front of “SCSI controllers”. “Win2000 Promise
MBUltra133 IDE Controller” should appear.
2. Choose “Add/Troubleshoot a device” and press “next” then new
hardware wizard will show device list.
3. Choose “Mass Storage controller“ and press “next” and next
screen press “finish”.
4. Choose ”display a list the known drivers for this device so that I
can choose a specific driver “then press “next”.
5. It will show all Windows 2000 supported SCSI adapter drivers.
Press “Have disk”.
6. Insert the MBUltra133 driver diskette in drive A:.
7. Type “A:\Win2000” in the text box. Then press “ OK ”.
8. Choose “Win2000 Promise MBUltra133 IDE Controller” from the
list that appears on screen, and then press the “Next” key.
9. Press “Yes“ to confirm continuing the installation and copy the
driver to system.
10. Remove the floppy diskette and click on “Finish” to restart the
system. Windows 2000 will then restart for the driver installation to
take effect.