Instruction manual

B-2
845PE Max2 ATX Mainboard
Windows 2000: Installing driver in existing Windows 2000 system
After installing the MBUltra133 card and rebooting your system, Win-
dows 2000 setup will show a “New Hardware Found” dialog box. Under Win-
dows 2000, “PCI Mass Storage Controller” will be displayed.
1. Choose “Add New Hardware Wizard” from the list, and then press
“Enter”.
Windows 2000: Installing driver during new Windows 2000 installation
1. Start the installation:
a. Floppy Install: Boot the computer with the Windows 2000
installation diskettes.
b. Floppyless Install: Boot from floppy and type “WINNT”.
After files have been copied, the system will reboot. On the
reboot, after the message “Setup is inspecting your
computer’s hardware configuration...” appears, press <F6>.
c. CD-ROM Install: Boot from the CD-ROM. After the mes-
sage “Press F6 if you need to install third party SCSI or
RAID driver” appears, press <F6>.
2. When the “Windows 2000 Setup” window is generated, press “S” to
specify an additional device(s)
3. Insert the Promise Technology
®
driver diskette into drive A: and
press “Enter” key.
4. Choose “Win2000 Promise MBUltra133 IDE Controller” from the list
appearing on screen, and then press the “Enter” key.
5. The Windows 2000 Setup screen will appear again saying “Setup will
load support for the following mass storage devices:” The list will
include “Win2000 Promise MBUltra133 IDE Controller”.
NOTE: If you need to specify any additional devices to be installed,
do so at this time. Once all devices are specified, continue to the next
step –
6. From the Windows 2000 Setup screen, press the “Enter” key. Setup
will now load all device files and then continue the Windows 2000
installation.
Installing Drivers