User`s manual

Chapter 3 Configuring the System
60
Sensor: Assign the sensor and its condition to trigger the alarm. When the sensor’s condition
changes to one of these states: High electricity input or Low electricity input, it will trigger the
alarm.
Motion detection: Select the camera that has been set to trigger the alarm according to the
motion detection configuration in the Recording setup.
Video loss: Select which camera will trigger the alarm during the event of video signal loss.
Hard disk error: Select Hard disk error. When there is a hard disk error, the alarm
will be trigged.
After finishing settting the conditions, the lower table will show a new condition
item. Select the item to show the conditions. The condition icons turn red when
you see the item settings.
B. Action