User`s manual

Chapter 3 Configuring the System
54
3.5 Setting E-Map
Switch to E-Map to set up the settings.
Follow the steps below to set the E-map.
A. Enter your E-map’s name and No. in the blanks.
B. Click Import
to see a list. Select a source to load an E-map. The map must have been
saved in JPG format and the file size is smaller than 200KB.
Drag numeric buttons inside the camera column to the right E-map to indicate the actual
locations of the assigned cameras. After setting cameras, drag numeric buttons in Sensor and
Relay columns and repeat the same procedure. The locations of each icon on the E-map
indicate actual locations of cameras, sensors and relay devices.