User guide

PAGING: Both manual and pre-programmed pages are supported with the capability of sequential checklist paging.
Pre-programmed lists can be created to provide Group Paging and any pre-programmed page (single or group) can be
assigned to a paging button that can be placed on the GUI. The paging formats listed below are available:
 5/6 Tone
 256 custom Quik-Call II Formats (Customize, Tone, Duration, Inter-Tone Gap)
 Customer Formats
 Digital Dial 1500 Hz
 Digital Dial 2805 Hz
 Quik-Call
 Quik-Call II Tone and Voice
 Quik-Call II Tone Only
 Quik-Call II Battery Saver
 Single Tone
 Touch Code (DTMF)
 Knox
PATCHING and MULTISELECT: Each operator position can support up to 11 patches and 11 multiselects, each one
supporting 16 members, a resource cannot be a member of more than one active patch or multiselect.
CHANNEL CONFIGURATIONS: MCC 5500 shall support the following Channel configurations with 4 wire, 600 audio
connection. All channels support analog operation with MDC signaling if configured.
MDC
 OUTBOUND MESSAGES
 Call Alert
 PTT ID
 Radio Check
 Radio Disable
 Radio Enable
 Radio Status Request
 Remote Monitor
 INBOUND MESSAGES
 Call Alert
 Emergency Alarms
 Emergency Call
 PTT ID
 Radio Message
 Radio Status
ASTRO
 OUTBOUND MESSAGES
 Call Alert
 PTT ID
 Radio Check
 Radio Inhibit
 Radio Status Request
 Radio Uninhibited
 Remote Monitor
 INBOUND MESSAGES
 Call Alert
 Emergency Alarms
 Emergency Call
 PTT ID
 Radio Message
 Radio Status
 Status Query Response
iDEN
 OUTBOUND MESSAGES
 Call Alert Encode
 Emergency Call Encode
 Group Call
 Private Call
 Outbound PTT ID
 INBOUND MESSAGES
 Call Alert Decode
 Emergency Call Decode
 Inbound PTT ID
 Private Call
Pa
g
e 4 of 16Dispatch Solutions \ MCC 5500 Dispatch Console
2/17/2015mk:
@
MSITStore:C:\Users\case02\Documents\ECAT
_
DUP
_
Feb
_
2015\ECAT.chm::/MCC5500.
...